jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Power Amplifier TROUBLESHOOTING
SYMPTOM No audio (POWER LED is off) No audio (PROTECT LED flashes every 4 sec.) No audio (PROTECT LED is on) LIKELY CAUSE No voltage at BATT+ or REM terminals, or bad or no ground connection DC voltage on amplifier output SOLUTION Check voltages at amplifier terminals with VOM Amplifier may need service; see enclosed warranty card for service information Make sure amplifier cooling is not blocked at mounting location; verify speaker-system impedance is within specified limits (see �Specifications� on the next page) Check vehicle charging system for defective voltage regulator Check INPUT LEVEL setting; see previous page Check vehicle charging system for defective voltage Check INPUT LEVEL setting; or check speaker wires for shorts or grounds Remove speaker leads one at a time to locate shorted speaker or wire, then repair Check speaker connections for proper polarity
PX300.4
Amplifier is overheated
No audio (PROTECT and POWER LEDs flash) I-E/OPT LED is on all times (not flashing) No audio (PROTECT LED is on) Distorted audio
Voltage less than 9V on BATT+ connection
Amplifier is being overdriven Voltage more than 16V or less than 8.5V on BATT+ connection regulator Input sensitivity is not set properly, or amplifier or source unit is defective Short circuit in speaker or wire
Distorted audio and PROTECT LED flashes Music lacks �punch�